Hydraulic punching is the low cost way to make holes in structural shapes.

Reduce your "per hole" and material handling costs and boost your productivity with a portable hydraulic press – available in flange and web models.

Versatile hydraulic presses can travel to the work site, mount on a production work bench, float over the work table by a suspension spring, and even be "ganged" to produce multiple holes at one time.

Hydraulic power units, available in 1-1/2, 3, 10 and 20 horsepower models, are selected based on your requirement for capacity and cycle time. Some units are available in two or three valve models to allow operation of additional equipment.

Punch round, square, obround and rectangular holes in I-beams, channels, angle iron, plate and wide-flange beams.